LOG 归档 - 第20页共139页

Junos Interface Damping: Suppress Physical Link Flaps

Configure Junos physical interface damping to stop a flapping link flooding routing protocols: penalty 1000, suppress and reuse levels, hold-time guid

admin 2026-10-03

0 0 0

BGP Route Flap Damping Parameters Explained

Understand BGP route flap damping: half-life, reuse, suppress and max-suppress defaults, how the figure-of-merit decays, plus a Junos policy example.

admin 2026-10-03

0 0 0

SONiC CLI Cheat Sheet: show, config and docker Commands

A practical SONiC cheat sheet: show interfaces and routes, config commands, config save and reload, plus docker and redis-cli commands for troubleshoo

admin 2026-10-03

0 0 0

Catalyst 9300: StackWise-480 vs StackWise-1T vs VSS

Compare Cisco Catalyst 9300 stacking options: StackWise-320/480/1T bandwidth, ring throughput, mixing rules and how it differs from VSS designs.

admin 2026-10-03

0 0 0

Leaf-Spine vs Three-Tier: Oversubscription and ECMP Design

Compare leaf-spine and three-tier data center designs on oversubscription, ECMP bandwidth use and scale-out, with the ratios engineers should target.

admin 2026-10-03

0 0 0

华为S5700交换机恢复出厂配置实操：reset saved-configuration

华为S5700交换机恢复出厂配置实操：reset saved-configuration 清空配置、清空后重启、恢复默认参数的完整步骤与验证方法，含 reset saved-configuration 与 save 命令的校验步骤与常见误区。

admin 2026-10-03

0 0 0

Arista EOS Port-Specific VLAN Tagging: Access, Trunk, Native

Configure per-port VLAN tagging on Arista EOS: access and trunk mode, native and allowed VLANs, and the show commands that prove tagging works.

admin 2026-10-03

0 0 0

ArubaOS-CX vs AOS-S: VLAN and Trunk Command Mapping

Translate AOS-S untagged/tagged VLAN commands into ArubaOS-CX vlan access and vlan trunk syntax with a side-by-side table and verification steps.

admin 2026-10-03

0 0 0

Dell OS10 default interface: Reset Ports to Factory Default

How to use the Dell SmartFabric OS10 default interface command to clear port settings, why VLT discovery interfaces block it, and how to verify the re

admin 2026-10-03

0 0 0

MC-LAG ICCP Backup Liveness Detection Config Guide

Configure and verify Junos MC-LAG ICCP backup liveness detection: peer IPs, BFD timers, prefer-status-control-active and LACP system ID behaviour.

admin 2026-10-03

0 0 0